14-07-2022
door Admin Admin

Time to chop a top!

I checked the A-pillar for two similar widths around a 3" chop. The pivot point will be at the back at the engine bay. From there the chop will be from 0 to 3" at the A-pillar.

I took my time to measure, check, re-measure, re-check etc. etc. And then finally cut the roof and re-align the roof. cut again, re-align till I got it right. To slant the A-pillar I try to heatend that inside part but it was to strong and it didn't bend at all. so I had to cut the inside and outside to bend the A-pillar to get  it right. I bended it 38 degrees from start. It caused the roof the be shorter so I had to remove a 1 cm part. I slid the top of the a pillar to bend it to meet the lower part of the A-pillar. Finally I got it right, like I wanted is; A slightly slanted windscreen, a 3"drop and no strange body lines.

Check this preview

Opmerkingen

Geen berichten gevonden

Schrijf een beoordeling